Acpi Nsc1100 Driver T435/3/2021
Note that the driver in 2.6.12-mm2 is version 1.0.0 and does not use the latest firmware.Support for the relatively new machine should get much better over time, perhaps making much of this guide unnecessary.A great deal of useful information can be found in the T43 Category hardware page, and the other T-Series installation guides over on the Debian Category page.
Acpi Nsc1100 T43 Driver In 2If you want to keep Windows it may be a good idea to turn on the machine and let it go through the Windows setup process before shrinking the partition. One step of the process is to convert the FAT32 windows parition to NTFS. The FAT32 partition may be easier to resize, but ntfsresize in Linux works fine too. For easy resizing, boot up in Knoppix 3.9 with kernel 2.6 (earlier versions of Knoppix do not contain a 2.6 Kernel capable of handling the SATA drive). Once Knoppix is loaded head over to K-System-QtParted and you will be presented with a nice GUI for resizing the Windows partition. The Windows NTFS and IBM system restore FAT32 partitions take up 24 primary paritions, which doesnt leave much room for expansion. The reiser4 root parition here causes a lot of trouble because of the lack of widespread reiser4 support. The strategy here is to install the base system on sda6, compile a kernel with reiser4 support, and move everything back over to sda3. Obviously this can be skipped if you want to stick with ext3 or something else. The ext3 boot partition is also necessary since GRUB does not support reiser4 easily. In the beginning you may find it useful to have an extra copy of everything on sda6 to use as a fall back in case something goes wrong. Also a swap partition can be useful if you want to be able to hibernate using swsusp or Software Suspend 2 (note the latter can also use a swap file), or if you have less than 1GB of memory. The inside of the drive (last sectors) can be 50 slower than the outside (first sectors), so put frequently accessed portions up front. Acpi Nsc1100 T43 Drivers Without DMAIt will be necessary to boot with kernel 2.4 to install the system (using legacy IDE drivers without DMA support - slow but manageable). To get all the latest and greatest, edit aptsources.list by hand and put in. Dont worry since experimental packages must be manually installed. There is no need to install extra stuff at this point (X, etc) as it all can be taken care of after the system is working. Acpi Nsc1100 T43 Free Patches WhileYou can try to go the Debian-way and download the Debian source and non-free patches while using the Debian modules tools to add support for everything. I started with the original Debian 2.6.11-1 configuration file (found in boot), and made the major changes. While gcc 4.0 comes with Debian Unstable, you probably want to use gcc 3.3 (or 2.95 as some suggest). The config file also represents bootsplash 3.1.6 and a SATA ACPI suspend fix patches to the 2.6.12-mm2 kernel (see sections below). Assuming the everything is installed in the ext3 partition on devsda6, the steps are.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |